Panasonic Omnivision PV-V4611 - Page 24

Tape Operation
Search System
For each recording, an invisible index mark is placed
on the tape. A program index and information are also
included for timer recordings. These marks are used to
access or scan recordings.
Index Search
Press SEARCH*
to display SEARCH
in Stop or Play
mode.
ENTEA INDEX NUMBER :1
USING 1- 9 KEYS
FORWARD SEARCH :FF
| REVERSE SEARCH REW
2 Press number keys
to select recording
number.
e To calculate
number, see below.
Press FF or REW
to start search.
INDEX SEARCH * Play begins at
search end. To
search forward or
back 1 index,
press FF or REW
while screen left
is displayed (10
sec.).
FORWARD SEARCH : FF
REVERSE SEARCH : REW
MM To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press REW.
A dd:
|2 f3af4 js] e |7]
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press FF.
de ae. a
(112 fa [o js] e |7]
NOTE: + indicates start points of each recording.
e If Index Search is started very close to
an index mark, that index mark may not
be counted in the search.
Program End Search
Locates end point of recording for
continuity.
1 Press SEARCH twice
to display SEARCH in Stop or
Play mode.
Press FF
to start
PROGRAM
END SEARCH.
2
SEARCH START : FF
EXIT :-SEARCH
Examples
of
Program
End
Search.
Fig.
1
Lg
Program
aa
MB
Program
2 or
BLANK
J]
pain y
End Point
the current ta
Press SEARCH
Upon locating end point,
-->search continues 7 sec. past end point,
-->tape rewinds to 10 sec. before end point,
-->tape plays to end point and stops.
* If Program End Search is started very
close to an index mark, that mark may be
skipped over.
. To cancel, press PLAY or STOP.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com