Panasonic Omnivision PV-V4611 User Manual

"Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
Press CHA Key to start Channel/Clock
Auto Set operation. Settings are
performed automatically. If the setup is
completed, the following screen is
displayed.
VEA [ CLOCK | CHANNEL
571372001 SUN 2.20PM
Į:
SETTING : CH 10
AUTO CLOCK SET
COMPLETED
END ¿CH UP KEY
If “Auto Clock Set is Incomplete”
screen appears, set the clock using
MANUAL CLOCK SET procedure
shown below.
AUTO CLOCK SET IS
INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
Manual Clock Set
If Auto Clock Set was incomplete, manually
set the clock as follows.
Press ACTION Key on the Remote to
display CLOCK Menu screen.
[Ven [Clock] CHANNEL |
SELECT MONTH
SELECT: a Y
¿ACTION
Press A Y to select the month and »
to set. In the same manner, select and
set the date, year, time, and DST
(daylight saving time).
2
[VCR [CLOCK CHANNEL
1111172001 SUN 12:00PM
OST:ON
SET COMPLETED
SET 14»
TART: l
3
Press ACTION Key twice to start
CLOCK and exit.
POWER
VCR
VCR/TV
SELECT/
ACTION
CHA /v
Reset All VCR Memory Functions
Use when moving VCR to new
location, or if a mistake was made in
the Initial Setup section.
+ Make sure a tape is not inserted in
the VCR.
| Turn VCR
Power on.
2 Press and hold both
PLAY and CHANNEL |
Aon the VCR for
more than 5 seconds.
¢ The power shuts off.
3 Do “Initial Setup” on page 8.
O
Q
=)
=
1»)
O
=.
O
E
=]
=
D
YN
D
mp
=
5

Panasonic Omnivision PV-V4611 Specifications

General

Brand	Panasonic
Model	Omnivision PV-V4611
Category	VCR
Language	English