This unit can be set to automatically power on in one
of 3 modes (TV, Playback, or FM radio.)
You can also combine the On-Timer with a one
minute alarm that gradually increases in volume.
Press PROG/VCR+*
to display SET PROGRAM screen.
_IP Ready Check List
[] The clock is set to correct time.
2
SET PROGRAM
TIMER PRCG_AMMING
VCR Plus+ _NG
SELECT :i •
SET :1_
END :PROG
1) Press iV to select
"ON TIMER."
2) Press • to display
ON TIMER screen.
3
• ON-TIMER mode
selection order
(,_CH02_CH03'--'.CH 125'_ I
CH01 PLAY
1) Press lY to select
desired settings.
---_vg---_J-_........... 2) Press • to set the
_."1ill il[lillll _lllii_
ON-TIMER TIME or
SELECT :i v'
sET :_ ON-TIMER mode.
BND :PRO6
• Make sure a tape is
inserted if Playback mode
is selected.
• See "FM Radio" on page
22 for instructions on
how to preset FM
stations.
4
ON TIMER
CN_B.:ADD/DLT
SELECT:& •
SET :4 •
END :PROG
Press iT to select
ALARM "ON" or "OFF."
When "ON" is selected,
an alarm will gradually increase in volume for one
minute or until canceled by pressing any button
(including VOL + -).
To Make Corrections,
use iN and < • to move back and correct.
<Model PV-C2061 unit shown>
TIMER/FM
I I
CH A,V ON TIMER
Indicator
Press PROG/VCR+
to set ON TIMER.
• "ON TIMER SET" is displayed.
• ON TIMER Indicator lights on the unit.
To Cancel ON-TIMER set,
Repeat steps I and 2. Then, press ADD/DLT to clear
the time in step 3. Now, press PROGNCR+ to end.
"ON TIMER END" briefly appears on-screen.
If no button on the remote or unit
(including a button used to turn off
the alarm) is pressed within 60
minutes after unit turns itself on, it
will turn itself back off.
To Next Page
Loading...
