Panasonic Palmcorder PalmSight PV-L678 - Page 11

Supplying Power
AC Adaptor
payieys Bung
DC Power Cable
DC IN 1 Connect VCR DC OUT on the
Connector AC Adaptor to DC IN on the
Camcorder with the DC Power
Cable (supplied).
POWER Lamp
VCR OC OUT Connector ay
* The POWER Lamp will light.
Notes:
* AC Adaptor cannot be used to power the Camcorder while charging the Battery.
» While not in use, unplug the AC Adaptor from the AC outlet. (When plugged into an AC outlet, the
AC Adaptor consumes 1.2W of electric power when not in use.)
1 Connect a PV-C16 Car Battery Cord
(optional) to DC IN on the Camcorder.
Pria start your car engine, and then
insert the Car Battery Cord plug into
your cigarette lighter socket.
* A fuse is located in the lighter plug end of
the cord.
Should fuse replacement be necessary
use the exact current rating {in amps).
Notes:
* This cord can only be used in vehicles
equipped with DC 12V (negative ground)
batteries. Use only the specified car battery
cord. If you are not sure, check with your loca!
car/truck dealer.
+ To avoid blowing the fuse, be sure to start your
car engine before inserting the cigarette lighter
Car Battery Cord Cigarette plug of the Car Battery Cord into the lighter
; socket.
kopuonal Lighter Plug * Because the car is running while your
Camcorder is in operation, make sure
you're in a well ventilated area.
* Disconnect the cigarette lighter plug when
your Camcorder is not being used.
Cigarette Lighter
Socket (12V)
11