Panasonic Palmcorder PalmSight PV-L678 - Core Operations; Camera Recording Guide

Camera Recording
Before you begin...
* Connect the Camcorder to a power source.
* Insert a cassette with record tab (see page 12).
Simple Recording
1 Set the POWER switch to CAMERA.
The built-in Lens Cover opens.
EV
+ Make sure the
POWER switch is
fully rotated to
PAUSE
the CAMERA
position.
Record/Pause
== mode.
= 2
> With the Viewfinder Eye Cup
against your eye, adjust the Vision
Adjustment Control to your eye-
sight.
3 Slide the TAPE SPEED Selector to
SP or SLP (refer to page 12).
7: RA RECORD/PAUSE to start
recording.
The Tally Lamp and REC Indicator are
lit during recording.
RECORD
Press the RECORD/PAUSE again to
pause the recording.
Set the Power switch to OFF after
Note:
recording
is
finished.
+ When your Camcorder is aimed at excessively
bright objects, or bright lights, a vertical bar
may appear in the picture. This is a norma!
characteristic of the CCD pick-up device. Try
to avoid this when possible.
¢To remove the cassette
In Record/Pause mode, slide the TAPE
EJECT switch (refer to page 12).
23