Panasonic Palmcorder PalmSight PV-L678 - Page 30

Playing Back your Recordings
TV Playback or Viewing Before you begin...
Your Camcorder may be connected to a ¢ Connect the Camcorder to a power source.
TV to play back tapes or to view what you
are recording.
Í Set the POWER switch to VCR for
TV with AUDIO/VIDEO IN Jacks. tape playback.
Or, set to CAMERA to view what your
Back of TV Camcorder is recording.
Zia the TV ON and set it to LINE
INPUT.
Check your TV operating instructions.
Note:
If your TV has no VIDEO or AUDIO IN
jacks, select CH 3 or 4 on your TV to match
the CH 3/4 switch setting on the OPTIONAL
PV-RF16 RF Adaptor. Set the VCR/TV
selector on the RF Adaptor to VCR for
playback.
To Audio tn |
Audio/Video
Cable .
(Supplied)
ay
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
3 Start playback or begin a recording.
If you have connected the
Camcorder to your TV using the
PV-RF16 RF Adaptor and want to
watch TV only:
Set the POWER switch to OFF on the
To Audio/ f
Video Outi
RF Adaptor Camcorder.
(optional) VHF Antenna Then, set the VCR/TV Selector on the RF
Adaptor to TV.
300 ohm-75 ohm Now, turn the TV ON and select a
transformer channel.
{not supplied)
or F Connector
CATV System Installer
UHE antenna This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides
Selector
VHF Connecting
Cable
(not supplied)
To VHF Antenna
Terminal
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding system
of the building, as close to the point of cable
entry as practical.
30