56
Electrical Wiring
4. Place the wire-end sleeve into the socket on the connector and replace and tighten the re-
moved terminal screw using a at-blade screwdriver.
Special washer
Screw and special washer
Screw
Terminal plate
Wire
Wire-end sleeve
Wire
Wire-end sleeve
Shielded wire
1. Remove cable sheath not to scratch braided shield.
2. Unbraid the braided shield carefully and twist the unbraided shield wires tightly together.
Insulate the shield wires by covering them with an insulation tube or wrapping insulation tape
around wire.
Insulation tape Shield mesh
3. Remove insulation of signal wire.
Insulation tape Shield mesh
8 mm
4. Attach wire-end sleeves to the signal wires and the shield wires insulated in step 2 using a
crimping tool.
Wire-end sleeve
5. Connect the shield for the inter-unit control wiring to ground.
To Next Page
Loading...
