30
Bluetooth
®
- Hands-Free Phone
DISPDISP
Phone answering
Press [PHONE] during a call incoming.
The Bluetooth
®
indicator ( ) blinks during a call
incoming/making a call.
Notes:
¡ During a call incoming, the volume of this unit
automatically switches to 18, it restores to the
original volume setting when phone answering or
call rejecting.
¡ If the automatic answering function is activated,
conversation can be automatically started after
receiving a call. (Refer to the below.)
Phone hanging up
Press [PHONE] during a call.
Switching between the private
mode* and hands-free mode
Press [BAND] during a call.
The private mode and hands-free mode switch alter-
nately every time [BAND] is pressed.
(Private mode)
(Hands-free mode)
* The private mode is defined as the mode where
conversation is conducted with the mobile phone in
a usual manner without the hands-free function.
Incoming call rejection
Hold down [PHONE] for more than 2 sec-
onds during a call incoming.
Outgoing call termination
Hold down [PHONE] for more than 2 sec-
onds during making a call. (When other
party does not answer the call.)
Setting of automatic answering function
Hold down [PHONE] for more than 2 sec-
onds at the standby state.
The automatic answering function toggles between
ON and OFF every time
[PHONE] is held down for
more than 2 seconds.
(Automatic answering deactivated)
(Automatic answering activated)
Use of voice dial
1
Hold down [d] for more than 2 sec-
onds at the standby state.
2
Pronounce the name registered on the
telephone directory.
If the name matches with a piece of data on the
telephone directory registered with the mobile
phone, the telephone number of the name is
dialed.
Note: The Bluetooth
®
mobile phone itself must be
equipped and support voice dial function.
[PHONE]
picks up the phone,
makes a call, or rejects
the call.
[VOL]
switch the record
(PUSH SEL :Select)
selects items in the selection mode.
[BAND]
switches between the
private mode and hands-
free mode.
[d]
activates the voice dial.
To Next Page
Loading...
