34
Alarm Setting
DISPDISP
Alarm time setting
*The 12-hour system is used for example.
1
Hold down [ALM] (Alarm) for more than
2 seconds.
(Alarm time display)
“ALARM ADJUST” is displayed when the alarm
time is not adjusted.
2
Hold down [ALM] for more than 2 sec-
onds after the above display is shown.
Hour blinks
3
Adjust the hour.
[d] : Sets ahead.
[s] : Sets back.
Hour entered
4
Push [ALM].
Minute blinks
5
Adjust the minute.
[d] : Sets ahead.
[s] : Sets back.
Minute entered
6
Push [ALM] to complete.
Completed
The alarm is set to ON automatically after com-
plete alarm time setting.
Alarm indicator (
) lights.
Notes:
¡ When the clock (
a page 11) is not set, perform
and complete the alarm time setting, the clock
time will set to “13:00” automatically. Please read-
just the clock time depending on the actual clock
time.
¡ Hold down [d] or [s] to change numbers
rapidly.
¡ When you want to readjust the alarm time, repeat
steps 1 to 6.
[s]/[d]
sets the hour and minute
[ALM]
selects items in the
alarm time setting.
To Next Page
Loading...
