I Installation
Notes on connections
Turn off the power supply for all components before making any connections.
If the cables necessary for connecting a component to the system are not included with the component or available
as an option, you may need to fashion a cable to suit the component concerned.
Read the instruction manual for each system component carefully before connecting it.
If there is a lot of jitter in the video signal input from the video source, the picture on the screen may flicker. In this
case, it will be necessary to connect a TBC (time base corrector).
I
ConnectingtheAntenna/ CabletotheRFinTerminal(NoVCR)
Antenna Connection
For proper reception of VHF / UHF channels, an external antenna is required. For best reception an outdoor
antenna is recommended.
VHF Antenna
RF
Coaxial Cable
UHF Antenna
J
VHF/UHF TERMINAL
ON THE BACKOF THE
PROJECTIONDISPLAY
FW WARNING ,,
hen using Nut type RF coaxial cables, tighten with fingers only. Overtightening may damage terminals.
12
To Next Page
Loading...
