Panasonic PT-40LC12 - 480 P; 1080 I

Installation
Analog RGB signals that can be input
The table below lists the different types of analog RGB signals that can be input.
If a signal which differs greatly from any of the types listed below is input, the picture image may not be displayed
correctly, or a black background may be displayed. At this time, "signal" will flash in the on-screen display for about 5
seconds.
Mode type Information menu
display
VGA400 (70 Hz) VGA400 70Hz
VGA480 (60 Hz) VGA 60Hz
Macintosh 13" MAC 13
,m VESA400 (88 Hz) VESA 85Hz
"_ VESA480 (72 Hz) VGA 72Hz
VESA480 (78 Hz) VGA 75Hz
VESA480 (88 Hz) VGA 85Hz
SVGA (56 Hz) SVGA 56Hz
_, SVGA (60 Hz) SVGA 60Hz
E SVGA (72 Hz) SVGA 72Hz
8 SVGA (75 Hz) SVGA 75Hz
SVGA (85 Hz) SVGA 85Hz
Macintosh 16" MAC 16
* XGA (60 Hz) XGA 60Hz
* XGA (70 Hz) XGA 70Hz
* XGA (75 Hz) XGA 75Hz
* Macintosh 19" MAC 19
* XGA (85 Hz) XGA 85Hz
480 i 480 i
480 p 480 p
720 p 720 p
"1080 i 1080 i
Notes:
• Input signals, other than those listed with a * mark, will give you a beautiful, stable picture.
• The front D-SUB15P connector can accept RGB(H-V sync separate) and RGB(sync on green). However, it is
not guaranteed to display stable color when using RGB(sync on green).
• When used with an external video processor/scaler, it must have RGB(H-V sync separate) output.
No. of dots
(Hx V)
640 X 400
640 X 480
640 X 480
640 X 400
640 X 480
640 X 480
640 X 480
800 X 600
800 X 600
800 X 600
800 X 600
800 X 600
832 X 624
1 024 X 768
1 024 X 768
1 024 X 768
1 024 X 768
1 024 X 768
664 X 488
720 X 483
1 280 X 720
1 920 X 1 080
Signal data
Horizontal frequency
(kHz)
31.47
31.47
38.00
37.86
37.86
37.80
43.27
38.16
37.88
48.08
46.88
83.67
49.73
48.36
56.48
60.02
60.24
68.68
18.73
31.47
48.00
33.75
Vertical frequency
(Hz)
70.08
59.94
66.67
85.08
72.81
75.00
85.01
56.28
60.32
72.19
75.00
85.06
74.58
60.00
70.07
75.03
74.93
85.00
29.97
59.94
60.00
30.00
19