Installation
How to connect the PC Input Terminals
COMPUTER _ (_)
E
_ ___/ _ PCaudiocable(M3 stereominipin)
V _ #ennue_oaoCu_b__WhimChn_la_nh_eScomputer.
onversionadapter(Ifnecessary)
=1__ RGBcable(D.SUB15P)
Signal Names for D-SUB 15P Connector
Pin No.
1
2
3
4
Pin Layout for PC Input 5
Terminal 6
7
8
Signal name Pin No. Signal name
R 9 NC
G 10 Ground
B 11 NC
NC 12 NC
NC 13 HD/CSYNC
Ground for R 14 VD
Ground for G 15 NC
Ground for B
NC: Not connected
Notes:
• Some PC models cannot be connected to the set. A conversion adapter is required to use the RGB cable (D-SUB
15P) to connect a Macintosh computer to the set. There isno need to use an adapter for computers with PC / AT
compatible D-SUB 15P terminal.
• The computer shown in the illustration is for example purposes only. Additional equipment and cables shown are not
supplied with this set.
• The picture will become dark if an RGB signal with a vertical scanning frequency of 62 Hz is input. To obtain the
optimum picture quality with the projection display, a vertical scanning frequency of 60 Hz is recommended.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
• Select the desired RGB input position by pressing the TV/VIDEO button. (E 33)
18
To Next Page
Loading...
