Panasonic PT-LB382

ENGLISH - 71
4) Press the <ENTER> button.
f [Remote control] is set.
Note
f To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
f When the ID number is set to [ALL], the projector will operate regardless of the ID number specied by remote control. If
multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectors with
other ID numbers.
f Refer to “Setting the remote control ID numbers” (x page 43) for how to set the ID number on the remote control.
[Factory default]
Return various setting values to their factory default settings.
1) Press as to select [Factory default].
2) Press the <ENTER> button.
f The [Return to Factory default?] screen is displayed.
3) Press as to select [Yes] and then press the <ENTER> button.
f The [OK?] screen is displayed.
4) Press as to select [Yes] and then press the <ENTER> button.
f The [Please wait] message will appear, and resetting operation will start, and after completing the operation, the
[Please wait] message will disappear.
Attention
f After executing the [Factory default], be sure to turn off the projector (x page 37), disconnect the power plug from the wall
outlet, and then turn on the projector in order to reect the initial setting values.
Note
f When [Factory default] is executed, all setting values except for User Logo, PIN code lock, Logo PIN code lock, Lamp
counter, Filter counter and Logo select will be returned to the factory default settings.
Chapter 4 Settings - [Expand] menu