30-E
NGLISH
Selecting the input signal
(INPUT SELECT/ DIRECT INPUT SELECT)
You can select the input signal by pressing the INPUT SELECT button or the
DIRECT INPUT SELECT buttons.
Press the INPUT SELECT button.
BThe input signal selected will change as shown
below each time the INPUT SELECT button is
pressed.
Projector control
panel
INPUT SELECT
button
Control
panel
Remote
control
unit
Changing signals
Press the DIRECT INPUT SELECT buttons.
BYou can select the input signal directly.
DIRECT INPUT
SELECT buttons
Remote
control
unit
Changing signals
The signal that is being input to the
PC 1 IN connector will be projected.
The signal that is being input to the
PC 2 IN connector will be projected.
The signal that is being input to the S-
VIDEO IN connector will be projected.
The signal that is being input to the
VIDEO IN connector will be projected.
The signal that is set by the wireless
network will be projected. (page 56)
NOTE:
B“PC2” cannot be selected when “PC2 SELECT” in the “OPTION” menu is
set to “OUTPUT”.
To Next Page
Loading...
