EasyManua.ls Logo

Panasonic PT-MZ13K

Panasonic PT-MZ13K
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Chapter 6Maintenance — Maintenance/replacement
ENGLISH - 209
Removing the air lter unit
Tabs on the projector body
Fig. 1 Fig. 2
Air filter cover
Air filter unitGrip
Air filter unit compartment and the
projector’s intake vent
Air filter cover fixing screw
1) Turn off the power of the projector.
f Always follow the procedure of “Switching off the projector” (x page 65) when turning off the power.
2) Remove the air filter cover. (Fig. 1)
f Turn the air lter cover xing screw (x 1) counterclockwise with a Phillips screwdriver until it turns freely, and
remove the air lter cover by placing a nger in the depressed section and pull it out slowly in the direction
of the arrow.
f When pulling out the air lter cover, make sure to place a hand on the air lter cover. Pulling it out too
rapidly may cause the air lter cover to fall.
3) Pull out the air filter unit. (Fig. 2)
f Slightly push the grip of the air lter unit inward in the direction of the arrow, remove from the tabs on the
projector body, and pull out the air lter unit.
f After pulling out the air lter unit, remove any foreign object and dust from the air lter unit compartment
and the projector’s intake vent.
Performing maintenance of the air lter unit
Remove the air lter unit in advance with the procedure for “Removing the air lter unit” (x page 209) described
previously.
Fig. 1 Fig. 2
1) Wash the air filter unit. (Fig. 1)
i) Soak the air filter unit in cold or warm water and then lightly rinse it.
f Do not use cleaning tools such as brushes.
f When rinsing, hold the frame of the air lter unit without putting strong pressure on the lter unit.
ii) Rinse the air filter unit two to three times using fresh water each time.
f Insufcient rinsing may result in odors.
2) Dry the air filter unit. (Fig. 2)
f Let the air lter unit naturally dry off in a well-ventilated place where there is little dust and is not exposed to
direct sunlight.
f Do not dry using drying devices such as dryers.
f After the air lter is dried, proceed to “Attaching the air lter unit” (x page 210) next.

Table of Contents

Related product manuals