Fig. D9
Reference <Notes> in Chart, Page 2-1:
1. When removing the Shield Case of the Power Supply Ass'y, twist and straighten 3
Locking Tabs (L-2) on the Power Supply AssÕy in Fig. D3. Then remove the Shield
Case by pulling it away from the Power Supply Ass'y.
2. To remove the Front Panel Ass'y:
A. Release Locking Tabs (L-4) in sequence as follows,
[1] Left Side [2] 2 Top Left [3] 2 Top Right
[4] Right Side [5] Use screwdriver for 2 Bottom
B. Work carefully so as not to break the Tabs.
To reinstall the Front Panel Ass'y:
A. Make sure as well as all locking tabs are aligned properly.
B. Press the Front Panel straight in.
Note:
If the Front Panel Ass'y is pressed in at an angle, operation buttons on the Main
48
To Next Page
Loading...
