Panasonic PV-A208 - TV Playback or Viewing

Playing
Back
your Recordings
TV
Playback
or Viewing
Your
Camcorder
may be connected to a
TV to play
back
tapes
or to view what you
are
recording.
Q
TV
with AUDIO/VIDEO IN Jacks.
^
Back of
TV
To
Audio
In
Audio/Video
Cable
(Supplied)
To
Audio/Video
Out
(
[
TV without
AUDIO/VIDEO
IN
Jacks.
^
To
Audio/
Video Out
Before you begin...
•
Connect the Camcorder to a
power
source.
Set
the POWER switch to
VCR
for
tape
playback.
Or, set to
CAMERA to view what your
Camcorder is
recording.
'Turn the TV ON and set it to LINE
INPUT.
Check your TV operating
instructions.
Note:
If your TV
has no
VIDEO
or AUDIO
IN
jacks,
select
CH
3 or 4 on your TV to
match
the CH 3/4
switch setting on the
OPTIONAL
|
PV-RF16 RF Adaptor. Set the
VCR/TV
selector on the
RF Adaptor
to
VCR for
playback.
1
Start playback or begin a
recording.
If you
have
connected the
Camcorder to
your TV using the
PV-RF16 RF
Adaptor
and want to
watch TV only:
Set the
POWER
switch to OFF on the
Camcorder.
Then, set
the VCR/TV Selector
on
the RF
Adaptor
to
TV.
Now, turn the TV ON and
select
a
channel.
VCR/TV
Selector
VHF Connecting
Cable
(not supplied)
To VHF Antenna
Terminal
CATV System Installer
This reminder is provided to call the
CATV
system installer's
attention
to
Article
820-40
of the
NEC
in
USA
(and
to
the
Canadian
Electrical Code
in Canada) that
provides
guidelines for
proper grounding
and,
in
particular, specifies that
the
cable
ground
shall
be
connected to the grounding
system
of
the building, as close to the point
of
cable
gentry as practical.
27