24
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
Before Using
• If the built-in battery is weak, the [ ] Indication
flashes. In this case, charge the built-in battery.
• The clock uses the 12-hour system.
Setting Date and Time
Since the internal clock of the Camcorder has a
slight imprecision make sure to check the time before
recording.
1 Set [ BASIC] >> [ CLOCK SET] >> [YES].
30
2 Move the Joystick Control [Ż] or [Ź]
35
to select the item to be set. Then move the
Joystick Control [Ÿ] or [ź]
35
to set the
desired value.
• Year will cycle in the order shown below.
2000, 2001, ..., 2089, 2000, ...
3 Press the Joystick Control
35
to fi nish
setting the date and time.
• The clock operation starts from [00] second.
CLOCK SET
JAN /01/2005 12AM:00
SETUP
SET ENTER EXIT
• Set to Tape/Card Recording Mode.
35
34
Internal Lithium Battery Recharge
The internal lithium battery sustains the operation
of the clock. If the [
] or [--] is indicated when the
Camcorder is turned on, the internal lithium battery is
near exhaustion.
1 Connect the AC Adaptor to the Camcorder
with the power turned off and then connect
to the AC jack.
• After charging for 4 hours, the built-in lithium battery
can power the clock for approximately 3 months.
• Leave the Camcorder as is for approx. 24 hours, and
the battery will drive the Date and Time for approx.
6 months. (Even if the [OFF/ON] Switch is set to
[OFF], the battery is still being recharged.)
LP Mode
You can switch the tape recording speed.
• Set to Tape Recording/Playback Mode.
Set [ BASIC] or [ ADVANCE] >> [ REC
SPEED] >> [LP].
If the LP mode is selected, the recording
time will be 1.5 times the SP mode, but some
functions will be disabled.
• We recommend using the SP mode for important
recordings.
• In order to fully exhibit the performances of the LP
mode, we recommend using Panasonic cassettes
marked LP mode.
• Audio dubbing is not possible with LP Mode. (p. 41)
• In the LP mode, the picture quality will not be
degraded in comparison with the SP mode, but
mosaic noise may appear on the playback image or
some functions may be disabled.
- Playback on other digital video equipment or on
digital video equipment without the LP mode
- Playback of the image on other digital video
equipment recorded in the LP mode
- Slow Motion/Still Advance playback
Audio Recording Mode
You can select the sound quality of the recorded
sound.
• Set to Tape Recording Mode.
Set [ SETUP] >> [ AUDIO REC] >> [12bit] or
[16bit].
High sound-quality recording is possible with “16 bit
48 kHz 2 track” Mode. With the “12 bit 32 kHz 4 track”
Mode, the original sound can be recorded on 2 tracks
in stereo, while the other 2 tracks can be used for
Audio Dubbing.
About date/time
• The Date and Time function are driven by a
built-in lithium battery.
• Make sure to check the time before recording
because the built-in clock is not very accurate.
To Next Page
Loading...
