EasyManua.ls Logo

Panasonic PV-GS19 - Playback Mode; Playing Back a Tape; Adjusting Sound Volume; Finding Scenes for Playback

Panasonic PV-GS19
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
35
Playback Mode
SP 3h59m59s29f
R2:00
12:34:56AM
JAN 2 2005
SP 3h59m59s29f
R2:00
12:34:56AM
JAN 2 2005
Playing Back a Tape
The recorded scene can be played back immediately
after the recording.
1 Set the [OFF/ON] Switch
28
to [ON].
The [POWER] Lamp
32
lights up.
2 Set the Mode Dial
34
to Tape Playback
Mode.
The One-Touch Navigation icon is displayed on
the lower right of the screen.
3 Move the Joystick Control [Ż]
35
to rewind
the tape.
Rewind the tape to the point where you want to
start playback.
When the tape reaches the beginning, rewinding
stops automatically.
4 Move the Joystick Control [Ÿ]
35
to start
playback.
• The [Ź] Indication appears.
To Stop Playback
Move the Joystick Control [ź] to select [ ].
Adjusting the Sound Volume
Finding a Scene You Want to Play
Back
Cue/Review Playback
If the Joystick Control [Ź] or [Ż]
35
is moved
during Playback, it turns to Cue Playback
A
or
Review Playback
B
.
If the Joystick Control is held continuously, it turns to
Cue Playback or Review Playback until you release
it.
During Cue/Review playback, fast-moving images
may show noise as a mosaic.
Before and after Cue/Review playback, the screen
may become blue for a moment or images may be
distorted.
34
14
For other notes concerning this item, see page 62.
A
B
If a cassette recorded with copyright protection
signal is played back, the picture is distorted by
mosaic-like patterns.
28
32
35
35
SP 3h59m59s29f
R2:00 ɱ
12:34:56AM
JAN 2 2005
35
SP 3h59m59s29f
R2:00 ɱ
12:34:56AM
JAN 2 2005
35
Playback Mode
35
Set to Tape Playback Mode.
The One-Touch Navigation icon is displayed on the
lower right of the screen.
On the Remote Control, press the [T] Button to
increase the volume or the [W] Button to decrease
it. (PV-GS35 only)
When the adjustment is completed, the volume
indication [
] will disappear.
If you do not hear the sound, check the settings of
[
SETUP] >> [ 12bit AUDIO].
Adjust the speaker volume for playback.
1 Push the [– / VOL +] Lever
14
to adjust
the volume.
Towards [+]: increases the volume
Towards [–]: decreases the volume
(The closer to [+], the higher the volume.)
[One-Touch Navigation icon]

Table of Contents

Related product manuals