Panasonic Quasar Omnivision PVQ-1311 - Page 76

Adjustment :
Pair of 4-Pole Convergence Magnet Rings,
Pair of 6-Pole Convergence Magnet Rings
Specification :
Refer to descriptions below.
INPUT :
Video Input Jack,
Crosshatch Pattern Signal,
Mode :
STOP
Equipment :
NTSC Video Pattern Generator
1. Supply a Crosshatch Pattern Signal to the Video Input Jack.
2. Turn the Pair of 4 - Pole Convergence Magnet Rings so that B and
R, at center of CRT, overlap each other.
3. Turn the Pair of 6 - Pole Convergence Magnet Rings so that B and
R, that overlapped each other in step 2 overlaps G.
7.3.13. DYNAMIC CONVERGENCE ADJUSTMENT
Purpose:
To set the uniform convergence over the whole screen.
Symptom of Misadjustment:
The convergence on the screen will vary at the sides of the CRT.
Test Point :
----------
Adjustment :
Deflection Yoke (CRT Unit)
Specification :
Refer to descriptions below.
INPUT :
Video Input Jack,
Crosshatch Pattern Signal,
White Pattern Signal
76