Panasonic Quasar Omnivision PVQ-1311 - Page 79

Monoscope Pattern Signal
Mode :
STOP
Equipment :
NTSC Video Pattern Generator
(For model with 13 inch CRT)
1. Supply a Monoscope Pattern Signal to the Video Input Jack.
2. Select H CENTER in EVR adjustment mode and adjust so that A is
approximately equal to width B.
3. Select V SIZE in EVR adjustment mode and adjust so that the top
3rd line is just in view.
4. Confirm that the 10th dotted line is in view and that the 11th line is
out of view.
If the line are not positioned correctly, select V POSITION in
adjustment mode and adjust correctly.
Fig.E12-1
(For model with 20 inch CRT)
1. Supply a Monoscope Pattern Signal to the Video Input Jack.
2. Select H CENTER in EVR adjustment mode and adjust so that A is
approximately equal to width B.
79