Note:
1. When recording in Service Position (2), short the S-Tab SW. Pins
on foil side of TV/VCR Main C.B.A. to turn this SW. on.
Fig. 2-3
2. When disassembling/assembling, refer to "CABINET SECTION" in
DISASSEMBLY/ASSEMBLY PROCEDURES.
5.1.3. HOT CIRCUIT
Primary circuit exists on the TV/VCR Main C.B.A.
This circuit is identified as " HOT " on the C.B.A. and in the Service Manual. Use extreme care to
prevent accidental shock when servicing.
5.1.4. SERVICE MODE
In order to inhibit detection of the Supply & Takeup Photo Transistors, Reel Sensor, and Cylinder
Lock, place a jumper between TP6001 and GND.
In this mode, Mechanism movement can be confirmed. When removing Cassette Up Ass'y, it can
be confirmed without a cassette.
To release from this mode, remove the jumper between TP6001 and GND.
11
To Next Page
Loading...
