5.1.5. CAUTION FOR INSTALLATION OF VCR UNIT
CAUTION:
Opener Lever may be damaged when VCR Unit is installed, with Cassette Door-Lid and Opener
Lever of Cassette Up Ass'y set incorrectly.
Install the VCR Unit as follows:
1. Swing the Cassette Door-Lid all the way open until the Cassette
Door tab clears the Opener Lever.
2. Make sure that all guide tabs are aligned properly. Then, press the
VCR Unit straight in.
Fig. 3
5.1.6. HOW TO INITIALIZE MEMORY IC
After the Memory IC (IC6004) or TV/VCR Main C.B.A. is replaced, be sure to set the Default value
to Memory IC as shown in "Memory IC Reference Table" below.
1. Press and hold STOP, PLAY, and VOL DOWN buttons on the unit
together over 5 seconds with no cassette inserted.
The adjustment overlay will appear to Enter EVR Adjustment mode.
Fig. 4-1
2. Set the Default value of all Control functions using a remote
control as shown in "Memory IC Reference Table."
Note:
12
To Next Page
Loading...
