3 kHz±5 Hz
14 % or 7 % Modulating
6. Adjust R9008 (SEP (H) ) on the Audio C.B.A. so that the signal
level of TP9001 is minimum.
Fig. E2
7.3.5. SEPARATION ADJUSTMENT (Model: L)
Note:
Be sure to perform this adjustment after STEREO/SAP
SEPARATION ADJUSTMENT are completed.
Purpose:
To separate the L and R Channels of Stereo Signal.
Symptom of Misadjustment:
The L and R Channels of Stereo Signal will not be separated
properly resulting in no stereophonic effect.
Test Point:
TP4202 (Audio C.B.A.)
Adjustment:
R9003 (Audio C.B.A.)
Specification:
minimum level
INPUT:
Antenna Input Terminal
MTS (ONLY L CH)
300 Hz±5 Hz
14 % or 7 % Modulating
Mode:
59
To Next Page
Loading...
