4. Confirm that the 10th dotted line is in view and that the 11th line is
out of view.
If the line are not positioned correctly, select V POSITION in
adjustment mode and adjust correctly.
Fig. E12-1
(Model: H, I, J, K, L)
1. Supply a Monoscope Pattern Signal to the Video Input Jack.
2. Select H CENTER in EVR adjustment mode and adjust so that A is
approximately equal to width B.
3. Select V SIZE in EVR adjustment mode and adjust so that the top
4th line is just in view.
4. Confirm that the bottom 3rd line is in view and that the bottom 4th
line is out of view.
Fig. E12-2
77
To Next Page
Loading...
