Panasonic QUINTRIX TX-86PW300A - Getting Started: Initial Setup; Connecting the Aerial; Connecting the Power

6
Getting Started
Connect the Aerial
The RF (Aerial) Input impedance of this television is 75Ω. If your aerial lead is 300Ω ribbon (two wires
separated by a flat plastic strip) you will require a 300Ω/75Ω Balun (not supplied) in order to connect your
aerial to the television.
Note:
For your safety any external aerial should be installed by a reputable qualified installer and should comply
with Australian Standard AS1417.1.
In New Zealand the installation should comply with International Standard IEC597-1.1.
Connect the Power Plug
The televisions are designed for the Australian Standard Mains Voltage of 240V 50Hz and the New Zealand
Standard Mains Voltage of 230V 50Hz.
NOTE:
If the television is not going to be used for an extended period, remove the power plug from the wall outlet.
Turn on the Television
Push the Power Switch to turn the television ON.
Sit back and enjoy your new Panasonic television.
Power Switch
S-VIDEO
VIDEO
L
AUDI O
R
AV5 I NAV 2 IN
CO M PONENT
MONITOR OUT
R
P
B
P
Y
MONOMONO
AV4 IN
CO M PO NE NT
R P
B
P
Y
MONO
AV1 IN
P ana son ic AV C Ne tworks Aus tr a lia Pt y . Ltd.
Di stribut ed in Australia by Panason ic Au str alia Pty. Ltd.
Di stribut ed in New Zealand by Panasonic NZ . Ltd. A uckland New Zeal and
MODEL TX-86 P W300A
CHASSIS GP 1E
220 ~ 24 0V 50H z 179 W
PA RT No . TBM 4A 0162
DO NO T REM O VE THI S C O VER.
NO US ER SE RVICE ABLE PA RTS INSIDE.
REFE R SE R VI CI NG TO QUALIFIED TEC HNICI AN .
WA RNI N G - D A NG ERO US VO LTAG E INS I D E.