Panasonic RQ-382 - Location of Controls and Components

LOCATION OF CONTROLS AND COMPONENTS
Monitor Jack [MONIT (8Q)/o3.5]
Microphone Jack [MIC 200~6000/93.5]
Sensitivity Switch [MIC SENS]
Pause Switch [[PAUSE]]
VAS/Fast Play
Switch [|VAS] F- PALY]
Stop Button [m@ STOP]
Fast/Cue Buttons
[3 FAST/CUE]
Playback Button
a
[> PLAY]
DISASSEMBLY INSTRUCTIONS
tt ee eee ail __}+—p=— =
Serene
eT
eee
SN
=
Remove the screw (A) (2x 8)mm x2.
Remove the screw (B) (1.6 x 4)mm x2.
3. Push the rib with screwdriver in the direction of
arrow and remove the Rear Cabinet Ass’y.
nN
af
{
\
()
\
/
aa
|
i ei
ls
7
\—_—_sr,
__
=
=
Fig. 3
5. Remove the screw (C) (1.6x4)mm x1 and then
remove the microphone holder and microphone.
Direction Selector
[DIRECTION]
Tape Counter and Reset Battery Compartment
Button [COUNTER]
Speaker
VAS
Level/Volume
Control
[4.5cm/8Q]
{VAS LEVEL/VOLUME]
Recording/Battery Check
Indicator [REC/BATT]
Built-in Microphone
[MIC]
Record Button [@ REC]
Cassette Holder
DC Input Jack
[DC IN3 VO]
PC Board, Mechanism
Microphone
Fig. 2
4. Open the bottom of the front cabinet in the direc-
tion of arrow @, and remove the PC board and
mechanism in the direction of arrow @. (Be
careful not be break the microphone wire.)
Note: When removing the PC board and the mecha-
nism, the jack cover and microphone sen-
sitivity selector knob will come off, so be
careful not to lose them.
(Assembly precaution: Mounting the Battery Ter-
minal after aligning the Battery Terminal with the
Rear Cabinet Ass’y.)
Fig. 4
6. Remove the screw (D) (1.6 <4)mmx1.
= 2 =