Panasonic RQ-382 - Measurements and Adjustments

SaaS
—
Fig. 5 Fig.6
7. Push the rib with the end of a Phillips screw- 8. Turn the speaker in the direction of the arrow to
driver to remove the cassette compartment. remove it.
MEASUREMENTS AND ADJUSTMENTS
@ ALIGNMENT INSTRUCTION
READ CAREFULLY BEFORE ATTEMPTING ALIGNMENT
1. Set volume control to maximum. 4. Set PAUSE OFF/Lock switch to OFF.
2. Set F. PLAY/VAS switch to OFF. 5. Set power source voltage to 3V DC.
3. Set MIC SENS switch to OFR.
@ ADJUSTMENT
ADJUSTMENT
POINT
MEASUREMENT
INPUT POINT
: QZZCFM Headphones Maximum Head adjustment
Head azimuth (8kHz, —20dB) | jack output screw
REMARKS
SPECIFICATION
Before measurement,
poe azzcwat | Headphones Oe ee: Short the silt(a) | short the silt (A) and
: jac : y soldering. open the sli y
(u adjustment) (RMS) soldering.
(1) Playback the test
tape in both
forward and reverse
directions.
Tape speed eZCWhi beg 3000+ pp Hz VR2 (2) Adjust VR2 to obtain
J counter readings
within specified
tolerances for both
directions.
@ ADJUSTMENT POINT
Azimuth Adj. Screw
=
||
Tape
eased
Adj.
VR
Fig.
1
Fig.
2