Panasonic RS-B25 - Dolby NR Circuit Performance

@ Dolby NR circuit Condition: Equipment:
¢ Record mode ¢ EVM (Electronic Voltmeter) ¢ AF oscillator
¢ Dolby NR switch...IN/(OUT ¢ ATT ¢ Oscilloscope
¢ Dolby NR select switch ¢ Resistor (600Q)
...BIC
¢ Input level controls...MAX
Record side
¢ Check of the Dolby-B type encoder characteristics
. Make connections as shown in fig. 17.
. Set the unit to the record mode. (NR select switch is OUT.)
. Apply a 1kHz signal to LINE IN.
. Adjust the ATT so that the output level at Pin 7 of 1C401 (L-CH) and 1C402 (R-CH) is 12.3mV.
. The output level at pin 21 should be OdB (375mV).
.
Set
the
NR
select
switch
to
B,
and
make
sure
that
the
output
signal
level
at
pin
21
of
10401
(L-CH)
and
1C402
(R-CH) is +6+1.5dB (753mV).
. Set the NR select switch to OUT, and adjust the frequency
to 5kHz. The output signal level at pin 21 should be 0dB.
(375mvV).
. Set the NR select switch to B and make sure that the
Output signal level at pin 21 of 1C401 (L-CH) and IC402
(R-CH) is +8+1.5dB (948mV).
¢ Check to Dolby-C type encoder characteristics
9. Repeat steps 1-5 above.
10. Set the NR select switch to C and make sure that the
output signal level at pin 21 of 1C401 (L-CH) and IC402 :
(R-CH) is +11.5+2dB (1.4V). AF oscillator ATT. 6002
11. Set the NR select switch to OUT and adjust the frequency rae eo EVM Oscilloscope
to 5kHz. The output signal at pin 21 should be OdB.
12. Set the NR select switch to C and make sure that the
output signal level at pin 21 of 1C401 (L-CH) and 1C402 Fig. 17
(R-CH) is +8.5+2dB (1V).