Panasonic RX-5080F - Power Source

fies:
@ Battery Operation:
1) Open the battery compartment cover as shown in the figure.
2) Insert 8 ‘‘D’’ size (National UM-1 or equivalent) batteries into the
battery compartment, making sure that the batteries are installed
in the specified numerical order and that the proper polarities are
maintained.
3) Replace the compartment cover.
Battery removal
When removing the batteries, press the ® side of the number ‘‘8”
battery toward the © side. Then, remove the batteries in the reverse
order from installation.
Note:
To operate on battery power, unplug the AC power cord from
the household AC power outlet and the AC Socket on the
unit.
Battery life
When the batteries are weak, the tape speed will slow down, the
sound will become distorted, and the volume will decrease.
Set the Function Selector to ‘POWER |OFF//TAPE”.
Depress the Playback Button. When the Power/Battery Check
Indicator goes out or dims, it is time to replace all the batteries with
new ones.
POWER SOURCE |
POWER/BATT “0: NORMAL
POWER/BATT REPLACEMENT
Note:
When the Function Selector or other controls are switched,
the indicator may tight. This does not indicate that anything is
wrong with the set.
@ AC Power Operation
1) First, check the AC Voltage Selector to insure that it is set to the
voltage which corresponds to your household AC voltage. If not,
adjust by inserting a small screwdriver into the slot provided and
turning the screwdriver until the desired voltage appears through
the opening.
110-115 V
115-127V 200-220 V 230-250 V
2) Connect the accessory AC power cord to the AC Socket in the
unit and your household AC power outlet. Upon plugging the
power cord into the AC Socket, the unit will automatically switch
from battery to AC operation.
AC power outlet
+
AC power cord
@ Car Battery Operation:
1) Insert the plug of the car battery adaptor cord into the DC Input
Jack.
2) Plug the other end into the cigarette lighter socket in your car.
Upon plugging the car battery adaptor cord in the DC Input Jack,
the unit will automatically switch from internal battery to car
battery operation.
©
t\
DC IN 13.2V
(O-2-®)
Cigarette
lighter
socket
Car Adaptor
(RP-952, optional)
Note:
For the connection of an adaptor cord, follow the instructions
provided with it.