Panasonic RX-5090 - AC Power Connection; Automobile Battery Power

m AC Power
Connect
one
end
of
the
AC
power
cord
(included)
to
the
AC
Connection
Socket
of
this
unit,
and
connect
the other end to an electrical outlet.
Note:
©
Be
sure
to
disconnect
the
AC
power
cord
from
the
AC
Connection
Socket
(AC
IN)
of
this
unit
when
using
batteries
as
the
power
source.
Disconnecting
it
only
from
the
electrical
outlet
is
not
sufficient.
Ifit
is
not
also
disconnected
from
the
AC
Connection
Socket
of
this
unit,
batteries
cannot
be
used
as
the
power source.
m@ Automobile battery
To
use
an
automobile
battery
as
the
power
source,
connect
the
Panasonic
Car
Adaptor
RP-917
(sold
separately)
between
the
Car
Battery
Input
Jack
of
this
unit
and
the
cigarette
lighter
receptacle
of
the
automobile.
2
AC
Socket
igarette
Lighter
t
CS
ee Socket
AC IN Jack
AC Power Cord (included)
Car Adaptor
(Use only RP-917 optional)
DC IN 9V Jack
(O->@)
TO LISTEN TO THE RADIO
1. Set the Function Selector to the ‘‘RADIO” position.
2. Set the Band Selector to either “FM” or ‘“AM” position.
3.
Set
the
Meter
Selector
Switch
to
the
“TUNING/BATTERY”
position.
,
4.
Set
the
Mode
Selector
to
the
“STEREO”
or
“MONO”
position.
if
EM
stereo
broadcasts
cannot
be
received
satisfactorily
(the
stereo
eye
flickers
on
and
off,
excessive
noise
is
heard,
etc.)
in
a
place
where
signals
are
weak
(far
from
the
broadcast
station,
in
a
concrete
building,
etc.),
set
the
Mode
Selector
to
the
“MONO”
position.
The
broadcast
cannot
then
be
heard
in
stereo,
but
it
will
be
easier
to
hear.
5.
Set
the
Volume
Control
to
the
preferred
position
and
tune
in
the
station,
making
sure
that
as
many
LEDs
as
possible
come
on
and
that
the
sound
quality
is
optimum.
6.
The
volume
can
be
adjusted
with
the
Volume
Control,
the
tone
quality
can
be
adjusted
with
the
Tone
Control,
and
the
left
and
right
balance
can
be
adjusted
with
the
Balance
Control.
7.
The
radio
can
be
turned
off
by
setting
the
Function
Selector
to
the
“OFF”
position.