Panasonic RX-FT560 - Measurement and Adjustment Procedures; Alignment Instructions; LW, MW, SW Radio Alignment; FM Radio Alignment

•This unit has an Automatic Levei Control (the recording
level is automatically adjusted).
•Recording and erasure of recording can be made only in
the forward direction.
B Recording Radio Broadcasts
1. Follow the procedure described in “RADIO''.
2. Insert the cassette tape into the Cassette Compartment.
3. Press the Record Button.
4. To stop the recording, press the Stop/Eject Button.
5. Set the Function Selector to “TAPE ToffI " to turn the unit
off.
Note:
The Graphic Equalizer and Extra Bass System does
not function when recording. Only the monitor sound
is affected.
•Beat Proof Switch
When an AM broadcast is recorded, the Beat Proof Switch
can be used to reduce unwanted "beat" signals (whistle)
which are sometimes present. Set the switch to whichever
position best reduces these "beat” signals.
B Recording through the Built-in Microphone
The condenser microphone in this unit is omni-directional
(all directions), so that recordings can be made from any
direction.
1. Set the Function Selector to “TAPEy iOFFl ".
2. Set the Editing Mode Selector to “MIC".
3. Follow the procedure described in steps (2)-(4) of
“Recording Radio Broadcasts”.
Note:
Do not press the Deck 1 Playback Button during
recording, otherwise the sound of Deck 1 is also
recorded.
B Recording from External Equipment
(Refer to page 10)
1. Connect the output of the external equipment to the
CD/Line Input Jacks.
2. Set the Function Selector to “fCDl/LINE".
3. Follow the procedure described in steps (2)-(5) of
"Recording Radio Broadcasts".
B Pause Button
The Pause Button can be used to temporarily stop the tape
from moving during recording or playback.
Before beginning a recording, first press and lock the Pause
Button. Then press the Record Button. (The tape will not
move.) When ready to record, press the Pause Button to
release it. This will start tape movement for immediate
recording.
Note:
Do not use the Pause Button to stop the tape for a
long period of time.
The unit is not turned off when the Pause Button is
pressed. Always use the Stop/Eject Button to turn the
unit off.
fl Monitoring
The monitor system enables you to listen, through the
Speakers or Headphones, to the sound as it is being
recorded.
If it is necessary to adjust the volume level of the sound
being monitored, do so by using the Volume Control.
•When recording from the Built-in Microphone, the sound
being recorded cannot be monitored.
B Erasure of Recording
When recording, previously recorded signals on the tape will
be erased automatically.
To erase a tape without re-recording, use the following
procedure. (Make no connections to the CD/Line Input
Jacks.)
1. Set the Function Selector to “ lCDl /UNE”.
2. Press the Record Button.