u
¡ When it receives a broadcast station, it
automatically stops. ¡ Repeat the same
operation until you receive your favorite station.
RQT6953
twenty three
When there is a
lot of noise in FM
stereo broadcasting
Press
to switch the reception
mode
Automatic
tuning (auto tuning)
Place the unit near a window and adjust the length and orientation of the FM
whip antenna.
Place the unit near a window and adjust the position and orientation of the
AM loop antenna.
Remote control only
i
Listen to the radio
ENTER
1
2
3
Turn on the power
Select “FM” or “AM”
Match the frequency
Keep tilted until the
frequency starts moving, then
release your finger
1
/
Press
FM
Press
When the reception condition of
reproduction
Tilt
AM
When the reception condition of
MONO
FM 76.0 MHz FM 90.0 MHz
TV 3ch TV 1chTV 2ch
2
/
Information
¡ AM and TV audio is monaural. ¡ Since the TV
reception circuit of this unit is also used as the FM reception circuit, FM
broadcasting may interfere with 2 or 3 channels.
¡ The sound will be monaural, but the noise
will be reduced and it will be easier to hear.
(Only when receiving FM 76.0 to 90.0
MHz) ¡ Normally, turn off “MONO”.
The TV reception position is:
Frequency
Every time you press ÿFM v AM
MONO ! Off
each time pressed (AUTO STEREO)
(Forced monaural) (Automatic discrimination)
Machine Translated by Google
To Next Page
Loading...
