Panasonic S-100PF1E5B - Page 153

1
1-11-52
If you wish to change the selected indoor unit, follow the
step (2).
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
(1)
Press and hold the
, and buttons
simultaneously for 4 seconds or longer.
(2)
If group control is in effect, press the
button to set.
At this time, the fan at the indoor unit begins and select
the address (unit No.) of the indoor unit operating.
(3)
Designate the item code “
” by adjusting the
Temperature Setting
/ buttons.
=91
=90
=92
=93
Electrical component box
(4)
Press the timer time
/ buttons to select the
desired setting data.
Flap position
1
2
3
4
5
* Setting data “ ”
Setting data Flap position during operation
Without separate setting
Swing
Move to position
1
and stay
Move to position
2
and stay
Move to position
3
and stay
Move to position
4
and stay
Move to position
5
and stay
NOTE
The flap swings during the operation under “Setting
the Flap Separately”.
At this time, the unselected flaps are moved to the
position
1
.
A
°
°
(5)
Press the
button.
(The display stops blinking and remains lit, and setting is
completed.)
If you wish to change the selected indoor unit, follow the
step (2).
(6)
(3)
(6) (1)
Press the
button to return to normal remote
controller display.
(4)
(2)
(4)
(2)
(5)
ECONAVI SYSTEM SETTING
Change the settings of main and sub indoor units to
correspond to the ECONAVI system function.
For the benefit of using the ECONAVI function, the main
indoor unit should be provided with the ECONAVI function.
1. Press three buttons.
Keep pressing the
, and buttons
simultaneously for more than 4 seconds.
The “Maintenance func” menu appears on the screen.
2. Select “0. ECONAVI info.” from the menu command.
By pressing the / buttons, select
“0. ECONAVI info.” and press the
button.
3. Select “System settings” from the menu command.
By pressing the / buttons, select
“System settings” and press the button.
4. Start settings.
By pressing the
/ buttons, select “YES” and
press the button.
5. When finished settings, the system restarts automatically.
6. Check whether the ECONAVI function is set.
is displayed on the screen.
If the display is not operated, press the
button
and set it in operating mode.
If operation is in fan mode,
is not
displayed. Set in any operating mode other than fan
mode.
“ ” is displayed when
setting the ECONAVI function.
NOTE
After operating Step 2, the following messages may occasionally appear on the screen.
Display message Contents
Disabled in default mode.After a while, select “0. ECONAVI info.” again.
If no status changes even after 10 minutes, make auto address setting and then
select “0. ECONAVI info.”.
After operating Step 3, the following messages may occasionally appear on the screen.
Display message Contents
Setup is not required. The main indoor unit has already been provided with the ECONAVI function.
So, it works right out of the box.
Main indoor unit is not found. The power of indoor unit may possibly shut down.
Check the power supply of indoor unit.
Indoor unit with ECONAVI is not found. Since all indoor units in the group control are not available for the ECONAVI
function, the ECONAVI function cannot be used.
SM830266-00_大洋州向けR32シングルTD&SM.indb 52 18/03/29 10:20:39