To Next PageTo Next PageWhy is my Panasonic S-100PU2E5B not cooling properly?
Poor cooling or heating performance in your Panasonic Air Conditioner can occur if the air intake or discharge port of the indoor and outdoor units is blocked by dust or other obstructions. To resolve this, remove any dust or obstructions. Also, check if the fan speed is set to 'Low'; if so, change it to 'Medium' or 'High'.
What to do if my Panasonic S-100PU2E5B won't turn on?
If your Panasonic Air Conditioner does not run even when the power is on, it could be due to a power failure. Press the ON/OFF operation button on the remote controller again. Alternatively, the operation button might be turned off; switch on the power if the breaker is off. However, if the breaker has tripped, it's important to consult your dealer without turning it back on. A blown fuse could also be the cause, and in that case, you should consult your dealer as well.
What to do if my Panasonic S-100PU2E5B is dirty because of oil mist?
If your Panasonic Air Conditioner is installed in a restaurant or a place with a lot of oil mist, the unit inside (heat exchanger) may get dirty. In this case, cleaning is necessary. It is suggested to contact your dealer.
Why does the fan keep running after I turn off my Panasonic Air Conditioner?
If the fan in your Panasonic Air Conditioner continues to run even after you've turned it off, this is normal and intended for smooth operation.
General| Brand | Panasonic |
|---|---|
| Model | S-100PU2E5B |
| Category | Air Conditioner |
| Language | English |
Procedures and locations for proper installation of the air conditioner unit.
Guidelines for electrical wiring, grounding, and compliance with local codes.
Steps to prepare the unit for operation, including pre-heating.
Advice on optimizing energy consumption during unit operation.
Instructions on how to adjust the airflow direction and related operations.
Steps for cleaning and maintaining the air filter of the unit.
Factors affecting heating performance, especially at lower temperatures.
Explanation of the automatic defrosting operation and its indicators.
Details on the dehumidification mode and its operational cycle.
How the unit behaves and resumes operation after a temporary power interruption.
