EasyManua.ls Logo

Panasonic S-100PF1E5B - Page 206

Panasonic S-100PF1E5B
259 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1
1-11-105
Finishing the Installation
After finishing insulating and taping over the tubing, use sealing
putty to seal off the hole in the wall to prevent rain and draft
from entering.
Apply putty here
Tubing
NOTE
See “Section 2. TEST RUN”.
NOTE
See “Section 8. HOW TO INSTALL THE WIRESS REMOTE
CONTROLLER RECEIVER”.
Accessories Supplied with Unit
Table 1-11-5 (Low Silhouette Ducted)
Part Name Figure Q’ty Remarks
Washer
8
For suspending indoor
unit from ceiling
Flare insulator
2 For gas and liquid tubes
Insulating
tape
2
For gas and liquid tubes
flare nuts
Drain
insulator
1 For drain hose joint
Hose band
1 For securing drain hose
Packing
1
For drain hose joint
(hard material)
Packing
1
For drain hose joint
(soft material)
Drain hose
1
Operating
Instructions
1
Installation
Instructions
1
Short-circuit
connection
1
For high static pressure
(Located on the back of
the electrical component
box lid. )
Use M10 for suspension bolts.
Suspension bolts and nuts are field supply.
Type of Copper Tube and Insulation Material
If you wish to purchase these materials separately from a local
source, you will need:
1. Deoxidized annealed copper tube for refrigerant tubing.
2. Foamed polyethylene insulation for copper tubes as
required to precise length of tubing. Wall thickness of the
insulation should be not less than 8 mm.
3. Use insulated copper wire for field wiring. Wire size
varies with the total length of wiring. See the section
“1-10. Electrical Wiring” for details.
CAUTION
Check local electrical codes and regulations before
obtaining wire. Also, check any specified instructions or
limitations.
Additional Materials Required for Installation
1. Refrigeration (armored) tape
2. Insulated staples or clamps for connecting wire (See your
local codes.)
3. Putty
4. Refrigeration tubing lubricant
5. Clamps or saddles to secure refrigerant tubing
6. Scale for weighing
HOW TO INSTALL THE TIMER REMOTE
CONTROLLER OR HIGH-SPEC WIRED
REMOTE CONTROLLER (OPTIONAL PART)
HOW TO INSTALL WIRELESS REMOTE
CONTROLLER (OPTIONAL PART)
SM830266-00_大洋州向けR32シングルTD&SM.indb 105 18/03/29 10:21:16

Table of Contents

Other manuals for Panasonic S-100PF1E5B

Related product manuals