Panasonic S-22KA1E5S - 11.13 WIRELESS REMOTE CONTROL CZ-RWS1; CZ-RWC1

157
11.13 WIRELESS REMOTE CONTROL CZ-RWS1 / CZ-RWC1
CZ-RWS1 (Cooling/Heating)
CZ-RWC1 (Cooling only)
• Before installing the infrared remote control, be sure to thoroughly read the “Precautions in terms of safety”
section of the installation instructions provided with the indoor unit.
• After installing the infrared remote control, carry out a test operation to check that the remote control functions
properly and also explain the operation and cleaning procedures to the customer in accordance with the details in
the instruction manual. Furthermore, ask the customer to keep this installation instructions and the operation
instruction in a safe place for later reference.
11.13.1 ACCESSORIES SUPPLIED WTH THE INFRARED REMOTE CONTROL
No. Name Qty. No. Name Qty.
○
1
Infrared Remote Control 1
○
4
Holder fixing screw 2
○
2
R03 battery 2
○
3
Holder 1
○
5
Installation instructions (This manual) 1
11.13.2 INFRARED REMOTE CONTROL OPERATION
• The infrared remote control can be used to operate indoor units at a maximum range of 8 meters from directly in
front of the indoor unit.
• If the remote control is at an angle to the receptor unit, the operating range may become shortened.
• If using a single remote control to operate several air conditioners, address setting will be required.
• (To be discussed later.)
INFRARED REMOTE CONTROL INSTALLATION PROCEDURE
(Use the holder to store the remote control.)
The remote control can be installed to the wall.
○
1
Secure the holder with the screws provided. (2 screw
locations)
○
2
Insert and remove the remote control by sliding it in/out
from the top of the holder.
Transmitter
ON/OFF switch
Cover
LCD
Remote controller holder
Secure the remote controller
holder to the wall using the 4
mm pan screws (accessory).
4 mm pan screws (accessory)
Be sure to only use the accessory
screws, otherwise the remote
controller may become dama
g
ed.
Note
• The holder should be in a place where it is not exposed to any type of heat (such as direct sunlight or near a
stove).
• The remote control may not transmit to the receiver properly while it is in the holder. Be sure to remove the
remote control unit from the holder and face the receiver when operating it.