56
(4) Setting the Flap Separately
1) The 4-air outlet flap can be adjusted separately
during operation. When not adjusted separately,
all flaps operate in the same manner.
<Procedure of CZ-RTC5B>
Refer to Section “Flap Setting for Each Air Outlet” in the Operating Instructions attached
to the optional High-spec Wired Remote Controller.
<Procedure of CZ-RTC4>
Stop the system before performing these steps.
1
Press and hold the
, and buttons
simultaneously for 4 seconds or longer.
2
If group control is in effect, press the
button
to set. At this time, the fan at the indoor unit
begins and select the address (unit No.) of the
indoor unit operating.
3
Designate the item code “XX” by adjusting the
Temperature Setting
/ buttons.
XX=91
XX=92
XX=93
Electrical component box
4
Press the timer time
/ buttons to select the desired setting data.
* Setting data “YYYY”
Setting data Flap position during operation
Without separate setting
Swing
Move to position
1
and stay
Move to position
2
and stay
Move to position
3
and stay
Move to position
4
and stay
Move to position
5
and stay
The flap swings during the operation under “Setting the Flap Separately”.
At this time, the unselected flaps are moved to the position 1
.
5
Press the
button.
(The display stops blinking and remains lit, and setting is completed.)
If you wish to change the selected indoor unit, follow Step
2
.
6
Press the
button to return to normal remote controller display.
Air outlet flap
(adjustment for up-down airflow direction)
A
°
°
5
6
2
2
4
3
4
YYYY
XX
1
2
3
4
5
Flap position
01_350115_EU_Eng.indb 56 2023/3/1 13:53:04
To Next Page
Loading...
