Panasonic S-36PF1U6 - Page 192

1-1851-184
1. Specifications
CZ-RWST2U
7-17. Supplied Accessories
7-18. Installing the Receiver
TD831159-042WAYVRF.indb21 2014/08/2613:48:00
Wireless Remote
Controller
(1)
Remote Control
Holder
(1)
AAA Size
Battery
(2)
Operating
Instructions
(1)
Wood Screw
(2)
Clamper
(1)
Supplied Accessories
1 Open the air inlet grill on the side panel. Remove the 1 screw and move it toward the front
(in the direction of an arrow) to remove it. (Fig. 1-223)
2 Wrap the tip of a slotted screwdriver with plastic tape and then insert it under the O-marked
surface of the cover, wiggling the cover free. (Fig. 1-224) (Be careful not to scratch the panel.)
3 After passing the lead wire through the panel, install the receiver in the hole in the panel.
(The projecting parts of the receiver is held in the hole in the panel.)
4 Fasten the receiver’s lead wire to the cable clip that is holding the wire from the louver motor.
(Fig. 1-225)
5 Attach the side panel.
6 Put the receiver’s lead wire together with other wires such as the louver motor wire, and fasten
them with the cable clip. (Fig. 1-226)
Use the hole in the upper part of the wiring box to lead it in.
For more information about wiring and test runs, see the sections on “Wiringfor the Receiver” and
“Test Operation”
Slotted screwdriver
(Wrapped with plastic tape)
Plastic tape
Insert it under the
O-marked surface
of the cover.
Side panel
Panel
Panel
Air inlet grill
Receiver
Cable clip
Cable clip
Cover
Fig. 1-226
Fig. 1-224
Fig. 1-225
Fig. 1-223
7-19. Self-diagnostics Table and Detected Contents
60LQGE 
The “Alarm Display” shown in the table below expresses the alarm contents displayed when the
wired remote controller is connected. For how to handle the alarms, see installation instructions
of indoor units or technical guide.
Detected contents Indication lamp on the receiver
Alarm Display
OPERATIONTIMERSTANDBY
Blinking
Communication error in the remote
controller circuit
Communication error either in the in/
outdoor operation line or the sub-bus of
the outdoor unit
Operation of indoor protection device
Alternately
Operation of outdoor protection device Alternately
Alternately
Alternately
Simultaneously
F30, F31 Simultaneously
Simultaneously
Simultaneously
conditioner
A01-A31
Simultaneously
Inconsistency in Cooling/Heating (Including an auto-temp
setting for a model without auto-temp settings)
Alternately
Oil alarm (Same as operation of outdoor protection device) Alternately
Test operation Simultaneously
: OFF : ON (Illuminated) : Blinking (0.5 seconds interval)
Emergency
operation button
Emergency
operation button
OPERATION
lamp
OPERATION lamp
TIMER
lamp
TIMERlamp
STANDBY
lamp
STANDBY lamp
Light receiving
section
Light receiving
section
1
SM830203-04.indb 184 15/10/16 10:45:23