Panasonic SA-DK20

Step 2 With lifting the claw in the direction of arrow 1, draw the
clamp SW P.C.B. in the direction of arrow 2.
Step 3 Remove the mechanism cover.
Step 4 Insert the gear with hexagonal wrench into the hole.
Step 5 Rotate the hexagonal wrench in the direction of arrow
(clockwise), and then open the disc tray fully.
Step 6 Upset the CD changer unit again.
Step 7 Release both the claws, and then draw the disc tray.
Step 8 With forcing the left guide bar manually because the left
guide bar interfers with claw, draw the disc tray.
• Installation of the disc tray after replacement
9.10. Disassembly and assembly of the Disc Tray
27
SA-DK20