Step 2 : Upset the CD loading unit.
Step 3 : Remove all the screws.
Step 4 : Unsolder the plunger terminals (2 points).
Step 5 : Unsolder the motor terminals (2 points).
Step 6 : Release the 2 claws (A), and then remove the Motor P.C.B.
Step 7 : Release the claw (B), and then remove the motor ass’y.
[Notice for motor ass’y installation]
1. Locate the name plate of motor to the traverse ass’y.
2. Align the hole of motor with the ribs.
To Next Page
Loading...
