Error Code Meaning System Computer Item Setting Task
in
F0BF 6) Unable to replay due to physical
layer identification failure
PCND_NOPLAY_PHYSICAL
0x50
DriveManager
F0C0 8) DVD: Unable to replay due to no
DVD Video/Audio/VR
PCND_NOPLAY_VIDEO
0x70
DiscManager
F0C1 9) DVD: Prohibited due to illegal
regional code
PCND_NOPLAY_RCD
0x80
DiscManager
F0C2 A) DVD: No replay due to PAL
system
PCND_NOPLAY_PAL
0x90
DiscManager
F0C3
B) DVD: All title replay prohibited in
parental setting
PCND_NOPLAY_PTL
0xA0
DiscManager
F0C4 C) VCD: Prohibited due to PHOTO
CD format
PCND_NOPLAY_PHOTOCD
0xB0
DiscManager
F0C5 D) VCD/CD: Prohibited due to CD-
ROM without CD-DA
PCND_NOPLAY_CDROM
0xC0
DiscManager
14.6. Mode Table 2
Following modes are available with combinations of the pressed buttons on the player and on
the remote controller unit.
Item Operational
Condition and
Key Function
Details
Display To
Jitter display While the
player is
stopped and
no disc is
inserted,
press and
hold down the
button on
the player and
the number
button, “5” on
theremote
controller unit.
Jitter display / Measures
and displays jitter.
Measurement is repeated
every second. Read error
counter starts at 0 at the
mode setting, and increased
by one as data read fails at
target block. A small defect
isallowed to correct by
retry. Any possibility is
counted as one increment.
Repetitive errors after retry
increase by two levels or
more.
J
*1
xxx
*2
_yyy
*3
_zz
*4
/ /
*1
:
Jitter display mode /
*2
:
Jitter measurement value /
*3
:Read error counter
/ *4
:
Focus driving value
Values are shown to one
decimal place in the decimal
digit.Focus driving value is
displayed in the hexadecimal
digit.
To Next Page
Loading...
