Panasonic SA-HT650P - Page 79

Pin
No.
Mark I/O Function
10 JOG1A I/O JOG 1 INPUT A. Main
Volume.
11 MIC_VOL I/O MIC VR AD input
12 DSPRST I/O DSP reset output.
13 DSPACK I/O DSP ACK input.
14 SENSE I/O DSP sense input.
15 PHONE I/O SW input for PHONE SW
detection. L: without
PHONE/ H:with PHONE
16 MIC SW I/O SW input for MIC
detection. L: without MIC
/ H: with MIC
17 VSS - GROUND (VPP power
input during FLASH)
18 RESET I Reset input. Active L.
19 N.C. L OPEN or GND with
Resistor
20 N.C. L OPEN or GND with
Resistor
21 VSS - GROUND (0V)
22 XIN I 4.00MHz Main Clock.
23 XOUT O 4.00MHz Main Clock.
24 VCC - Power Supply. (+5V)
25 EDA I/O EEPROM data output
26 ECK I/O EEPROM clock output
27 PCNT I/O PCNT output. Power
control output.
28 DCDET I/O DCDET input. DC power
detection input.
29 RDS CLK I/O RDS clock input
30 RDS DATA I/O RDS data input
31 RMT I/O REMOCON input.
Remote control input
32 SYNC I/O AC failure DET input.
Synchronized input for
detection of power
failure
33 SER4 I/O Serial 4 output
34 SER3 I/O Serial 3 output
35 SER2 I/O Serial 2 output
36 SER1 I/O Serial1 output
37 SER 5 I/O Serial 5 output (ECHO
CS)
38 ECS I/O EEPROM CS output