Panasonic SA-PM29E - Page 53

Pin No. Mark I/O Function
55 M1_R O Changer Motor 1 Reverse
Control
56 M1_F O Changer Motor 1 Forward
Control
57 M2_R O Changer Motor 2 Reverse
Control
58 M2_F O Changer Motor 2 Forward
Control
59 REC O when record circuit is operating
DURING RECORDING=H
60 KEY_LED O Dimmer ON=L, Dimmer Off=H-
61 PHOTO I PHOTO (SG Mechanism only)
62 VCC - Power Supply (+5V)
63 EE_DAT I/O EE_DAT
64 VSS - Ground (0V)
65 DMT O Deck Mute at mecha transition
L=mute OFF, H=mute ON
66 BP1 O AM beatproof 1 output L=BP1,
H=BP2
67 ASP_CLK O ASP CLK
68 ASP_DAT O ASP DATA
69 N.C. - No Connection
70 N.C. - No Connection
71 N.C. - No Connection
72 N.C. - No Connection
73 N.C. - No Connection
74 N.C. - No Connection
75 MEM_RST O Flash memory reset
76 MEM_WP O Flash Memory Write Protect
77 JOG1 I JOG SEARCH 1
78 JOG2 I JOG SEARCH 2
79 /CD O CD POWER CONTROL (Active
Low)
80 CD_RST O CD Reset Output
81 N.C. - No Connection
82 /RESTSW I CD Limit Switch Input for the
Most Inner Point (Active Low)
83 N.C. - No Connection
84 N.C. - No Connection
85 SSEQ_LED O Super Sound EQ LED Control
86 RE_LED O MP3/WMA Re-master Control
87 MOTOR O MOTOR Control Output L=OFF,
H=ON
88 PLUNGER O Deck PLUNGER Control Output
L=OFF, H=ON
89 DECK_AD1 I DECK AD Input 1
90 DECK_AD2 I DECK AD Input 2
91 REG1 I Region Setting 1
92 KEY3 I KEY3 INPUT
93 KEY2 I KEY2 INPUT
94 KEY1 I KEY1 INPUT
95 VOL_JOG1 I Volume Jog 1
96 AVSS - Analog Power Supply Input
(Connect to GND)
97 N.C. - No Connection
98 VREF - Reference for A-D (5V)
99 AVCC - Analog Power Supply Input
100 N.C. - No Connection
101
SA-PM29E / SA-PM29EB / SA-PM29EG