than the indicated rated impedance of the amplifierare used.
If this occurs, follow the procedure outlines below:
1. Turn off the power.
2. Determine the cause of the problem and correct it.
3. Turn on the power once again after one minute.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first turned
off and then on again.
3. Accessories
Note : Refer to Packing Materials & Accessories for part number.
Remote Control Transmitter
FM indoor antenna
AC mains lead (EG)
AC mains lead (EB)
4
To Next Page
Loading...
