3. Turn on the power once again after one minute.
Note:
When the protection circuitry functions, the unit will not operate unless the power is first turned
off and then on again.
5. Connection of the Speaker Cables
- Be sure to connect speaker cables before connecting the AC
mains lead.
- The load impedance of any speaker used with this unit must be 6 .
1. Connect with the included monaural connection cable to the
receiver or amplifier’s subwoofer output terminal.
2. Connect the AC mains lead to the household AC outlet.
6. Disassembly Procedure
“ATTENTION SERVICER”
Some chassis components may have sharp edges.
Be careful when disassembling and servicing.
1. This section describes procedures for checking the operation of
the major printed circuit boards and replacing the main
5
To Next Page
Loading...
