75Dcoaxialcable
(notincluded)
FMoutdoorantenna _
(notincluded)
@
30 mm
@
shield braid
(_) 15 mm
_,- Core wire
a
/
l
>{
_8
AM outdoor antenna
not included)
AMANT FM_T b_- 5 12 m
EXT LOOP Ii O 75_ (t6-40 ft.) ___b
_ AM loop antenna
(included)
You may need an outdoor antenna if you use this system in a
mountainous region or inside a reinforced-concrete building, etc.
FM outdoor antenna [] ]
Disconnect the FM indoor antenna if an FM outdoor antenna is in-
stalled.
_._ Remove a piece of the outer vinyl insulator.
Twist the shield braid•
(_ Expose the core wire.
An outdoor antenna should be installed by a qualified technician
only.
AM outdoor antenna []
q_
}4
_4
Connect the outdoor antenna without removing the AM loop anten-
na. Run 5 to 12 m of vinyl-covered wire horizontally along a window
or other convenient location.
When the unit is not in use, disconnect the outdoor antenna to pre-
vent possible damage that may be caused by lightning. Never use
an outdoor antenna during an electrical storm.
• For details, refer to the instruction manuals of the units which are
to be connected.
•When units other than these are to be connected, please consult
with your audio dealer.
This example shows how to connect an analog player with a
PHONe OUT/LINE OUT switch. []
_8
_ Analog player _:_.
(not included) _
_:_ _
"LINE OUT" position __,
Rear panel of this unit
player (not included)
_ AU r
Rear panel of this unit _:
• Only analog players with buitt-in phone equalizers can be con-
nected.
• Set the switch on the back of the analog player to "LINE OUT".
¢
This unit has Dolby Pro Logic circuitry. If the audio output of video
equipment is connected to the AUX terminal of this unit, the sound
will be reproduced with the same powerful stereophonic effects
found in movie theaters (,,,,page 30).
To Next Page