ePlug the AC power supply cord into a household AC outlet only
after an other connections have been made.
eTo prepare the antenna wires and speaker cords, twist the vinyl
cover tip end pull off.
o
X
O Connect the FM indoor antenna.
Tapethe antennatoe wall orcolumn,in a positionwhereradio
signalsare received withthe leastamountof interference.
J_r_
For best reception:
An FM outdoor antenna is recommended.
I_ Connect the AM antenna.
loop
After attaching the antenna, turn on the system and tune in a
broadcast station. Then, turn the antenna to the angle of best
reception and least interference.
[] Connect the front speakers.
Connecteach end ofthe speakercablestothe terminallevers
of thesame color.
Use only the supplied front speakers.
The combination of the main unit and front speakers provide the
best sound. Using other front speakers can damage the unit
and sound quality will be negatively affected.
To prevent damage to circuitry,never short-circuitpositive (+)
and negative(-) speakerwires.
[] Connect the center speaker.
]Connect the surround speakers.
[] Connect a TV (not included).
Connectavideoconnectioncordfromthissystem toyourTV.
I_']l
Set the voltage.
Use a flat-head screwdriver to turn the voltage selector of the
rear panel to the appropriate position for the area in which this
system is used.
Set the voltage selector to "220 V" or 530-240 V".
I_1 Connect the AC power cord.
M
If the power plug does not fit your socket, use the power plug
adaptor (included). []
Insertion of connector
Even when the connector is perfectly inserted, depending on
the type of inlet used, the front part of the connector may jut out
as shown in the drawing.
However there is no problem using the unit.
For your reference
information you enter into the unit's memory, except for the
time, remains intact for up to two weeks after the AC power sup-
ply cord is disconnected.
You may need an outdoor antenna if you use this system in a moun-
tainous region or inside a reinforced-concrete building, etc.
J FM outdoor antenna J B
Disconnect the FM indoor antenna if an FM outdoor antenna is in-
stalled.
An outdoor antenna should be installed by a qualified technician
only.
q
75_ coaxial
cable ._,
(not included)
GN
FM outdoor antenna
(not included)
O
_"_ 30 mm
(_) _ Shield braid
_--_15 mm
Core wire
J AM outdoor antenna ]
Connect the outdoor antenna without removing the AM loop anten-
na. Run 5 to 12 m of vinyl-covered wire horizontally along a window
or other convenient location.
When the unit is not in use, disconnect the outdoor antenna to pre-
vent possible damage that may be caused by lightning. Never use an
outdoor antenna during an electrical storm.
(not included)
RQTS067
To Next Page
Loading...
