Panasonic SC-HC212 - Making the Connections; Maintenance; Preparing the Remote Control

Confidential
Until:
02 Dec 2019
4
TQBJ2205
4
Making the connections
Connect the AC mains lead only after all the other
connections have been made.
1 Connect the DAB indoor antenna.
This unit can receive DAB/DAB+ and FM stations with
the DAB antenna.
Rotate the antenna at to improve reception.
Note:
• Do not use any other DAB antenna except the supplied one.
• Do not mount the DAB antenna on metal objects such as
water pipes or any metal parts of the building.
2 Connect the AC mains lead.
Do not use any other AC mains lead except the
supplied one.
Conserving power
The system consumes a small amount of power
(~14) even when it is in standby mode. Disconnect
the power supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Note:
• These speakers do not have magnetic shielding. Do not put
them near TVs, PCs or other equipment easily influenced by
magnetism.
• Tape the antenna to a wall with the least amount of
interference.
• Use an outdoor antenna (not supplied) if reception is poor.
Maintenance
Disconnect the AC mains lead before maintenance.
Clean this system with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this
system.
• Before using chemically treated cloth, read the
instructions that came with the cloth carefully.
Preparing the remote control
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align with
those in the remote control.
Adhesive tape
(not supplied)
Be sure to
tighten the nut
fully.
To household
mains socket
(not supplied)
HC212EG_TQBJ2205_En.Sw.Da.Fi.Po.Cz.book Page 4 Tuesday, November 12, 2019 2:39 PM
offset printing