Panasonic SC-HT80 - Disc Handling and Care; Disc Handling Precautions; Disc Storage and Unit Movement

I
Concerning discs
With this system, you can only play discs having these marks.
However, do not use irregular shaped discs. Discs of this sort can
damage the unit.
Handling precautions
• If you are taking the disc from a cold to a warm environment,
moisture may form on the disc. Wipe with a soft, dry lintfree cloth
before using the disc.
• Do not write on the label side with a bail-point or other writing
instrument.
• Do not use record cleaning sprays, benzine, thinner, static
electricity prevention liquids or any other solvent.
• Do not attach labels or stickers to discs. (Do not use discs with
exposed adhesive from tape or left over peeled off stickers.)
• Do not use scratch-proof protectors or cover than those specified
for use with this system.
• Do not use discs printed with label printers available on the
market.
Storage precautions
Be sure to store discs in their cases to protect them from dust,
scratches, and warping.
Do not place or store discs in the following places
• Locations exposed to direct sunlight
• Humid or dusty locations
• Locations directly exposed to a heat vent or heating appliance
• In the glove compartment or on the rear deck of an automobile
To prevent damage
Always observe the following points.
• Load only 1 disc per tray.
• Load discs as shown in figure.
• The adaptor is not needed with 8 cm discs (singles).
• Set the system on a flat, level surface.
Do not set it on top of magazines, inclined surfaces, etc.
• Do not move the system while trays are opening/closing, or
when loaded.
• Do not put anything except discs in trays.
• Do not use cleaning discs or discs which are badly warped or
cracked.
• Do not use discs with poorly attached labels or stickers.
Adhesive protruding from underneath stickers or left over from
peeled off stickers can cause your stereo to malfunction.
• Do not use irregular shaped discs.
When moving the unit _
1 Remove all discs.
2 Press [POWER] to turn the unit off.
3 Disconnect the AC power cord.